The axle assembly is done in accordance with all model specific components. In order to prepare the axle assembly all relevant components are preassembled in separate stages: anti-roll bar, differential, shock absorber, compliance bush etc. The axle, its components and other small items are put on a workpiece carrier (pallet) as required for model or type. In the conveyor section the pallet then moves the axle to the automatic bolting station where it is bolted. This is followed by an automatic measuring and setting station. Here axial run-out is measured, toe and camber are measured, set, and documented.

Minimum piece costs due to:

• Process equipment adapted to your product
• degree of automation determined according to financial prerequisites and quality standards
• Minimum surface area

Enhanced quality through optimized processes

High plant availability due to:

• Low failure rate
• Short maintenance and repair periods

Minimum initial start periods